Snmpv3 Trap Host Configuration - Lenovo RackSwitch G8264CS Application Manual

SNMPv3 Trap Host Configuration

554
G8264CS Application Guide for ENOS 8.4
To configure a user for SNMPv3 traps, you can choose to send the traps with both
privacy and authentication, with authentication only, or without privacy or
authentication.
This is configured in the access table using the following commands:
RS 8264CS(config)# snmp-server access <1‐32> level
RS 8264CS(config)# snmp-server target-parameters <1‐16> level
Configure the user in the user table accordingly.
It is not necessary to configure the community table for SNMPv3 traps because the
community string is not used by SNMPv3.
The following example shows how to configure a SNMPv3 user v3trap with
authentication only:
RS 8264CS(config)# snmp-server user 11 name v3trap
RS 8264CS(config)# snmp-server user 11 authentication-protocol md5
authentication-password
Changing authentication password; validation required:
Enter current admin password:
Enter new authentication password:
Re-enter new authentication password: <auth. password>
New authentication password accepted.
RS 8264CS(config)# snmp-server access 11 notify-view iso
RS 8264CS(config)# snmp-server access 11 level authNopriv
RS 8264CS(config)# snmp-server group 11 user-name v3trap
RS 8264CS(config)# snmp-server group 11 group-name v3trap
RS 8264CS(config)# snmp-server notify 11 name v3trap
RS 8264CS(config)# snmp-server notify 11 tag v3trap
RS 8264CS(config)# snmp-server target-address 11 name v3trap address
47.81.25.66
RS 8264CS(config)# snmp-server target-address 11 taglist v3trap
RS 8264CS(config)# snmp-server target-address 11 parameters-name v3param
RS 8264CS(config)# snmp-server target-parameters 11 name v3param
RS 8264CS(config)# snmp-server target-parameters 11 user-name v3trap
RS 8264CS(config)# snmp-server target-parameters 11 level authNoPriv
<admin. password>
<auth. password>