Lldp Example Configuration - Lenovo RackSwitch G8264CS Application Manual

LLDP Example Configuration

1. Turn LLDP on globally.
2. Set the global LLDP timer features.
3. Set LLDP options for each port.
4. Enable syslog reporting.
5. Verify the configuration settings:
6. View remote device information as needed.
548
G8264CS Application Guide for ENOS 8.4
RS 8264CS(config)# lldp enable
RS 8264CS(config)# lldp refresh-interval 30(Transmit each 30 seconds)
RS 8264CS(config)# lldp transmission-delay 2(No more often than 2 sec.)
RS 8264CS(config)# lldp holdtime-multiplier 4(Remote hold 4 intervals)
RS 8264CS(config)# lldp reinit-delay 2 (Wait 2 sec. after reinit.)
RS 8264CS(config)# lldp trap-notification-interval 5(Minimum 5 sec. between)
RS 8264CS(config)# interface port <n> (Select a switch port)
RS 8264CS(config-if)# lldp admin-status tx_rx(Transmit and receive LLDP)
RS 8264CS(config-if)# lldp trap-notification(Enable SNMP trap notifications)
RS 8264CS(config-if)# lldp tlv all
RS 8264CS(config-if)# exit
RS 8264CS(config)# logging log lldp
RS 8264CS(config)# show lldp
RS 8264CS(config)# show lldp remote-device
or
RS 8264CS(config)# show lldp remote-device <index number>
or
RS 8264CS(config)# show lldp remote-devices detail
(Transmit all optional information)