Lenovo RackSwitch G8264CS Application Manual page 205

9. Configure Internet‐facing interfaces.
10. Place the VLAG port(s) in their port LAGs.
11. Assign the LAGs to the VLAGs:
12. Verify the completed configuration:
© Copyright Lenovo 2017
RS 8264CS(config)# interface ip 1
RS 8264CS(config-ip-if)# ip address 172.1.2.11 255.255.255.0
RS 8264CS(config-ip-if)# vlan 30
RS 8264CS(config-ip-if)# enable
RS 8264CS(config-ip-if)# ip ospf area 1
RS 8264CS(config-ip-if)# ip ospf enable
RS 8264CS(config-ip-if)# exit
RS 8264CS(config)# interface ip 2
RS 8264CS(config-ip-if)# ip address 172.1.4.12 255.255.255.0
RS 8264CS(config-ip-if)# vlan 40
RS 8264CS(config-ip-if)# enable
RS 8264CS(config-ip-if)# ip ospf area 1
RS 8264CS(config-ip-if)# ip ospf enable
RS 8264CS(config-ip-if)# exit
RS 8264CS(config)# interface port 10
RS 8264CS(config-if)# lacp mode active
RS 8264CS(config-if)# lacp key 1000
RS 8264CS(config-if)# exit
RS 8264CS(config)# interface port 11
RS 8264CS(config-if)# lacp mode active
RS 8264CS(config-if)# lacp key 1100
RS 8264CS(config-if)# exit
RS 8264CS(config)# interface port 12
RS 8264CS(config-if)# lacp mode active
RS 8264CS(config-if)# lacp key 1200
RS 8264CS(config-if)# exit
RS 8264CS(config)# vlag adminkey 1000 enable
RS 8264CS(config)# vlag adminkey 1100 enable
RS 8264CS(config)# vlag adminkey 1200 enable
# show vlag information
Chapter 11: Virtual Link Aggregation Groups
205