Configuring Pvlan - Lenovo RackSwitch G8264CS Application Manual

Configuring PVLAN

1. Configure VLAN tagging/trunk mode for ports.
2. Create a VLAN and define the protocol type(s) supported by the VLAN.
3. Configure the priority value for the protocol.
4. Add member ports for this PVLAN.
5. Enable the PVLAN.
6. Verify PVLAN operation.
© Copyright Lenovo 2017
Follow this procedure to configure a Protocol‐based VLAN (PVLAN).
RS 8264CS(config)# interface port 1, 2
RS 8264CS(config-if)# switchport mode trunk
RS 8264CS(config-if)# exit
RS 8264CS(config)# vlan 2
RS 8264CS(config-vlan)# protocol-vlan 1 frame-type ether2 0800
RS 8264CS(config-vlan)# protocol-vlan 1 priority 2
RS 8264CS(config-vlan)# protocol-vlan 1 member 1, 2
Note: If VLAN tagging is turned on and the port being added to the VLAN has a
different default VLAN (PVID/Native VLAN), you will be asked to confirm
changing the PVID to the current VLAN.
RS 8264CS(config-vlan)# protocol-vlan 1 enable
RS 8264CS(config-vlan)# exit
RS 8264CS(config)# show vlan
VLAN Name
---- ------------------------
1 Default VLAN
2 VLAN 2
PVLAN Protocol FrameType
----- -------- ----------
2 1 Ether2
PVLAN PVLAN-Tagged Ports
----- ---------------------------
none none
Status
------ -------------------------
ena 1-48, XGE1-XGE4
ena 1 2
EtherType Priority
--------- --------
0800 2
Ports
Status Ports
------- -----------
enabled 1 2
147
Chapter 8: VLANs