LACP LAGs
© Copyright Lenovo 2017
The uplink used by vNIC groups can be a regular port, static LAG, or a dynamic
LAG. If you are using a dynamic LAG for the uplink, you must configure the same
LACP admin key for the vNIC uplink ports you want to group as a LAG on the
upstream switch. You cannot connect these vNIC uplink ports to multiple
upstream switches unless these switches are a single logical switch from LAG
perspective.
Use the following commands to add the LACP LAG as the uplink for a vNIC
group.
RS 8264CS(config)# vnic vnicgroup <vNIC group number>
RS 8264CS(vnic-group-config)# key <LACP admin key>
241
Chapter 14: Virtual NICs