Switching Mode; Npv Gateway; Npv Port Traffic Mapping - Lenovo RackSwitch G8264CS Application Manual

Switching Mode

NPV Gateway

NPV Port Traffic Mapping

© Copyright Lenovo 2017
For example:
RS 8264CS(config)# interface port 1,3-4
RS 8264CS(config-if)# switchport mode trunk
RS 8264CS(config-if)# switchport trunk allowed vlan 1,1002
RS 8264CS(config-if)# exit
RS 8264CS(config)# interface fc 62
RS 8264CS(config-if)# switchport trunk allowed vlan 1,1002
RS 8264CS(config-if)# exit
Notes:
The FCoE ports and FC Omni Ports must also be members of VLAN 1 and the

Fibre Channel VLAN.
 If using the BBI to add ports or remove ports to or from a Fibre Channel VLAN,
first apply the change and then proceed with further configuration.
The switch's role in the Fibre Channel network can be defined on a per‐VLAN
basis. The administrator can specify one of the following modes:
 NPV mode to uplink one or more nodes to a full fabric switch or Fibre Channel
devices
 Full fabric mode
The G8264CS supports up to 12 Fibre Channel VLANs at any given time. Only one
mode can be active on any specific VLAN at a given time, and only one VLAN can
operate in full fabric mode.
From within VLAN configuration mode, the following commands are used to
specify the Fibre Channel mode:
 To enable or disable NPV mode:
RS 8264CS(config-vlan)# [no] npv enable
 To enable or disable full fabric mode:
RS 8264CS(config-vlan)# [no] fcf enable
Note: When either NPV or full fabric mode are enabled, VLAN tagging is
automatically enabled on the VLAN.
The following section discusses the NPV gateway.
Within each VLAN used with Fibre Channel, the physical ports may be used in the
following roles:
Chapter 18: Fibre Channel
333