Lenovo RackSwitch G8264CS Application Manual page 278

278
G8264CS Application Guide for ENOS 8.4
The following rules apply to the local VM group configuration commands:
cpu: Enable sending unregistered IPMC to CPU.

flood: Enable flooding unregistered IPMC.

key: Add LACP LAGs to the group.

optflood: Enable optimized flooding to allow sending unregistered IPMC to

the Mrouter ports without having any packet loss during the learning period;
This option is disabled by default; When optflood is enabled, the flood and cpu
settings are ignored.
port: Add switch server ports or switch uplink ports to the group. Note that

VM groups and vNICs (see Chapter
simultaneously on the same port.
portchannel: Add static port LAGs to the group.

profile: The profile options are not applicable to local VM groups. Only

distributed VM groups may use VM profiles (see "VM Profiles" on page
stg: The group may be assigned to a Spanning‐Tree group for broadcast loop

control (see Chapter
tag: Enable VLAN tagging for the VM group. If the VM group contains ports

which also exist in other VM groups, enable tagging in both VM groups.
validate: Set validation mode for the group.

vlan: Each VM group must have a unique VLAN number. This is required for

local VM groups. If one is not explicitly configured, the switch will
automatically assign the next unconfigured VLAN when a VE or port is added
to the VM group.
vmap: Each VM group may optionally be assigned a VLAN‐based ACL (see

"VLAN Maps" on page
vm: Add VMs.

VMs and other VEs are primarily specified by MAC address. They can also be
specified by UUID, IP address, or by the index number as shown in various
VMready information output (see "VMready Information Displays" on
page 294).
vport: Add a virtual port to the group.

If VMware Tools software is installed in the guest operating system (see
VMware documentation for information on installing recommended tools), VEs
may also be specified by IPv4 address or VE name. However, if there is more
than one possible VE for the input (such as an IPv4 address for a VM that uses
multiple vNICs), the switch will display a list of candidates and prompt for a
specific MAC address.
Only VEs currently connected to the switch port (local) or pending connection
(pre‐provisioned) are permitted in local VM groups.
Because VM groups and vNIC groups (see Chapter
isolated from each other, VMs detected on vNICs cannot be assigned to VM
groups.
14, "Virtual NICs") are not supported
10, "Spanning Tree Protocols").
291).
280).
14, "Virtual NICs") are