RSTP Configuration Example
1. Configure port and VLAN membership on the switch.
2. Set the Spanning Tree mode to Rapid Spanning Tree.
3. Configure RSTP parameters.
4. Configure port parameters:
180
G8264CS Application Guide for ENOS 8.4
This section provides steps to configure RSTP.
RS 8264CS(config)# spanning-tree mode rstp
RS 8264CS(config)# spanning-tree stp 1 bridge priority 8192
RS 8264CS(config)# spanning-tree stp 1 bridge hello-time 5
RS 8264CS(config)# spanning-tree stp 1 bridge forward-delay 20
RS 8264CS(config)# spanning-tree stp 1 bridge maximum-age 30
RS 8264CS(config)# no spanning-tree stp 1 enable
RS 8264CS(config)# interface port 3
RS 8264CS(config-if)# spanning-tree stp 1 priority 240
RS 8264CS(config-if)# spanning-tree stp 1 path-cost 500
RS 8264CS(config-if)# no spanning-tree stp 1 enable
RS 8264CS(config-if)# exit