ACL Example 3
1. Configure an Access Control List.
2. Add ACL 2 to port 2.
ACL Example 4
1. Configure an Access Control List.
2. Add ACL 2 to port EXT2.
ACL Example 5
1. Configure Access Control Lists.
2. Add ACLs to a port.
126
G8264CS Application Guide for ENOS 8.4
Use this configuration to block traffic from a specific IPv6 source address. All
traffic that ingresses in port 2 with source IP from class 2001:0:0:5:0:0:0:2/128 is
denied.
RS 8264CS(config)# access-control list6 3 ipv6 source-address
2001:0:0:5:0:0:0:2 128
RS 8264CS(config)# access-control list6 3 action deny
RS 8264CS(config)# interface port 2
RS 8264CS(config-if)# access-control list6 3
RS 8264CS(config-if)# exit
Use this configuration to deny all ARP packets that ingress a port.
RS 8264CS(config)# access-control list 2 ethernet ethernet-type arp
RS 8264CS(config)# access-control list 2 action deny
RS 8264CS(config)# interface port 2
RS 8264CS(config-if)# access-control list 2
RS 8264CS(config-if)# exit
Use the following configuration to permit access to hosts with destination MAC
address that matches 11:05:00:10:00:00 FF:F5:FF:FF:FF:FF and deny access to all
other hosts.
RS 8264CS(config)# access-control list 30 ethernet
destination-mac-address 11:05:00:10:00:00 FF:F5:FF:FF:FF:FF
RS 8264CS(config)# access-control list 30 action permit
RS 8264CS(config)# access-control list 100 ethernet
destination-mac-address 00:00:00:00:00:00 00:00:00:00:00:00
RS 8264CS(config)# access-control list 100 action deny
RS 8264CS(config)# interface port 2
RS 8264CS(config-if)# access-control list 30
RS 8264CS(config-if)# access-control list 100
RS 8264CS(config-if)# exit