Basic System Mode Configuration Example; Transparent Mode Configuration Example - Lenovo RackSwitch G8264CS Application Manual

Basic System Mode Configuration Example

Transparent Mode Configuration Example

46
G8264CS Application Guide for ENOS 8.4
This example shows the parameters available for configuration in Basic System
mode:
RS 8264CS# easyconnect
Configure Basic system (yes/no)? y
Please enter "none" for no hostname.
Enter hostname(Default: None)? host
Please enter "dhcp" for dhcp IP.
Select management IP address (Current: 10.241.13.32)?
Enter management netmask(Current: 255.255.255.128)?
Enter management gateway:(Current: 10.241.13.1)?
Pending switch port configuration:
Hostname: host
Management interface:
IP: 10.241.13.32
Netmask: 255.255.255.128
Gateway: 10.241.13.1
Confirm erasing current config to re-configure Easy Connect (yes/no)?
Note: You can either accept the default values or enter new parameters.
This example shows the parameters available for configuration in Transparent
mode:
RS 8264CS# #easyconnect
Configure Transparent mode (yes/no)? y
Select Uplink Ports (Static Defaults:
The following Uplink ports will be enabled:
Uplink ports(1G/10G):
Select Server Ports (Static Defaults:
The following Server ports will be enabled:
Server ports(1G/10G):
Pending switch configuration:
Uplink Ports:
Server Ports:
Disabled Ports:
Confirm erasing current config to re-configure Easy Connect (yes/no)?
Notes:
 If your selection for a port group contains ports of different mode or speed, the
selection is not valid and you are guided to either select other ports or change
the speed of the ports.
You can either accept the static defaults or enter a different port list for uplink

and/or server ports.
17-24)?
17-24
25-64)?
25-64
17-24
25-64
1,5,9,13