Using 802.1P Priority To Provide Qos - Lenovo RackSwitch G8264CS Application Manual

Hide thumbs Also See for RackSwitch G8264CS:
Table of Contents

Advertisement

Using 802.1p Priority to Provide QoS

© Copyright Lenovo 2017
The G8264CS provides Quality of Service functions based on the priority bits in a 
packet's VLAN header. (The priority bits are defined by the 802.1p standard within 
the IEEE 802.1Q VLAN header.) The 802.1p bits, if present in the packet, specify the 
priority to be given to packets during forwarding. Packets with a numerically 
higher (non‐zero) priority are given forwarding preference over packets with 
lower priority value. 
The IEEE 802.1p standard uses eight levels of priority (0‐7). Priority 7 is assigned to 
highest priority network traffic, such as OSPF or RIP routing table updates, 
priorities 5‐6 are assigned to delay‐sensitive applications such as voice and video, 
and lower priorities are assigned to standard applications. A value of 0 (zero) 
indicates a "best effort" traffic prioritization, and this is the default when traffic 
priority has not been configured on your network. The switch can filter packets 
based on the 802.1p values. 
Figure 24. Layer 2 802.1q/802.1p VLAN tagged packet 
SFD
Preamble
Priority
7
6
5
4
3
Ingress packets receive a priority value, as follows: 
Tagged packets—switch reads the 802.1p priority in the VLAN tag. 
Untagged packets—switch tags the packet and assigns an 802.1p priority value, 
based on the port's default 802.1p priority. 
Egress packets are placed in a COS queue based on the priority value, and 
scheduled for transmission based on the COS queue number. Higher COS queue 
numbers provide forwarding precedence
To configure a port's default 802.1p priority value, use the following commands:  
RS 8264CS(config)# interface port 1
RS 8264CS(config-if)# dot1p <802.1p value (0‐7)>
RS 8264CS(config-if)# exit
DMAC SMAC
Tag
VLAN Identifier (VID)
7
6
5
2
1
0
E Type Data
FCS
4
3
2
1
0
Chapter 12: Quality of Service
223

Advertisement

Table of Contents
loading

Table of Contents