Setup Part 1: Basic System Configuration - Lenovo RackSwitch G8264CS Application Manual

Setup Part 1: Basic System Configuration

1. Enter y if you will be configuring VLANs. Otherwise enter n.
2. Enter the year of the current date at the prompt:
3. Enter the month of the current system date at the prompt:
4. Enter the day of the current date at the prompt:
5. Enter the hour of the current system time at the prompt:
6. Enter the minute of the current time at the prompt:
© Copyright Lenovo 2017
When Setup is started, the system prompts:
"Set Up" will walk you through the configuration of
System Date and Time, Spanning Tree, Port Speed/Mode,
VLANs, and IP interfaces. [type Ctrl-C to abort "Set Up"]
If you decide not to configure VLANs during this session, you can configure them
later using the configuration menus, or by restarting the Setup facility. For more
information on configuring VLANs, see the Lenovo Enterprise Network Operating
System Application Guide.
Next, the Setup utility prompts you to input basic system information.
System Date:
Enter year [2009]:
Enter the four‐digits that represent the year. To keep the current year, press
<Enter>.
System Date:
Enter month [1]:
Enter the month as a number from 1 to 12. To keep the current month, press
<Enter>.
Enter day [3]:
Enter the date as a number from 1 to 31. To keep the current day, press <Enter>.
The system displays the date and time settings:
System clock set to 18:55:36 Wed Jan 28, 2009.
System Time:
Enter hour in 24-hour format [18]:
Enter the hour as a number from 00 to 23. To keep the current hour, press <Enter>.
Enter minutes [55]:
63
Chapter 2: Initial Setup