Configuring Hot Links - Lenovo RackSwitch G8264CS Application Manual

Configuring Hot Links

516
G8264CS Application Guide for ENOS 8.4
 A port that is a member of the Master interface cannot be a member of the
Backup interface. A port that is a member of one Hot Links trigger cannot be a
member of another Hot Links trigger.
 An individual port that is configured as a Hot Link interface cannot be a
member of a LAG.
Spanning Tree Protocol must be disabled on Hot Links ports. For instance, if Hot
Links ports 1 and 2 belong to STGs 1 and 23, use the following commands to
disable the STGs:
RS 8264CS(config)# no span stp 1 enable
RS 8264CS(config)# no span stp 23 enable
Use the following commands to configure Hot Links.
RS 8264CS(config)# [no] hotlinks bpdu
RS 8264CS(config)# [no] hotlinks enable
RS 8264CS(config)# [no] hotlinks fdb-update (Enable or disable Hot Links FDB update)
RS 8264CS(config)# hotlinks fdb-update-rate (Configure FDB update rate in packets per
second)
RS 8264CS(config)# hotlinks trigger 1 enable (Enable Hot Links Trigger 1)
RS 8264CS(config)# hotlinks trigger 1 master port 1 (Add port to Master interface)
RS 8264CS(config)# hotlinks trigger 1 backup port 2 (Add port to Backup interface)
RS 8264CS(config)# hotlinks enable
(Enable or disable Hot Links BPDU flood)
(Enable or disable Hot Links globally)
(Turn on Hot Links)