Acknowledging Errors 4−5; Error Numbers 4−5; Acknowledging Errors; Error Numbers - Festo CPX Series Manual

4. Diagnosis and error treatment

4.2.2 Acknowledging errors

4.2.3 Error numbers

Error Malfunc
no. tion type
Warnings (CPX error category 0, no error in the CPX terminal, is not displayed at the CPX−MMI
handheld)
11 Warning
12 Warning
13 Warning
14 Warning
26 Warning
Festo P.BE−CPX−CMXX−E N en 0910a
You have the following possibilities to delete errors:
Acknowledge the error with CCON.Reset.
Acknowledge the error with the FCT.
Switch the operating voltage off and then on again.
The error messages of the CPX−CMXX can be found in the
following table.
Not all error messages can be displayed in the CPX terminal,
and so they are summarised in CPX error categories. Only the
CPX error categories are displayed at the CPX−MMI handheld.
Designation
(Cause)
Homing interrupted
(Positioning task is sent to axis while
homing is active)
Positioning interrupted
(Positioning task is sent to axis while
position record is active)
Reset interrupted
(Positioning task is sent to axis while
reset is active)
Axis stopped
(Positioning task is sent to axis while
axis stops)
Speed cannot be achieved
(Limit values of the axes are
incorrect or acceleration path is too
short)
Error handling
Send a positioning task only
·
when the homing run has been
ended.
Send a positioning task only
·
when the current position record
has been carried out.
Send a positioning task only
·
when reset has been ended.
Send a positioning task only
·
when the stop process has been
ended.
Check the position record
·
parameters and the axis
parameterisation.
4−5