System Commands - R&S NGE100B User Manual

®
R&S NGE100B
Parameters:
<Number>
See also
*RCL <Number>
Recall
Loads the instrument settings from an internal memory identified by the specified num-
ber. The instrument settings can be stored to this memory using the command
with the associated number.
Parameters:
<Number>
See also

7.2 System commands

The SYSTem commands perform the various system functions and configure the com-
munication interface (LAN, WLAN) for the instrument.
SYSTem:BEEPer[:IMMediate]
The instrument returns a single beep immediately.
Usage:
SYSTem:LOCal
This command sets the system to front panel control. The front panel control is
unlocked.
Usage:
SYSTem:REMote
This command sets the system to remote state. The front panel control is locked. By
pressing Remote, the front panel control will be activated.
Usage:
SYSTem:RWLock
This command sets the system to remote state. The front panel control is locked. You
are only able to unlock the front panel control via SCPI command
on page 73.
Usage:
User Manual 5601.1343.02 ─ 09
Range:
"Store instrument settings"
Range:
"Recall instrument settings"
Event
Event
Event
Event
Remote control commands
0..4
on page 52.
0..4
on page 53.
System commands
*SAV
SYSTem:LOCal
73