Learn Wireless Detectors; Set-Up For Peripherals - Honeywell Galaxy Flex V3 Series Installer Manual

Learn wireless detectors

Learn wireless detectors
Wireless Sensors and keyfobs can be learned provide that at least one RF Portal is
configured onto the system.
Learn new wireless detectors as follows:
1. On the keypad select Batch learn (
2. Press to enter Self-Learn mode.
3. Insert the battery in the detector and activate the tamper switch. The serial number of
the detector is recorded and displayed for 2 seconds. The panel provides a confirming
beep when each device is successfully learned.
If the signal strength is less than 3/10, the message signal strength too low is displayed
for 2 seconds.
4. If the RF device does not learn, remove the battery, short circuit the battery terminals,
replace the battery and repeat the above procedure.
5. Repeat the procedure from step 3 for each wireless device.
Note: Check individual detector manuals for information on power up times.

Set-up for peripherals

Some peripherals will require additional actions to complete their installation and set-up.
There is additional information on each peripheral in Appendix G at the back of this manual.
28
Galaxy Flex Installer Manual
).
52 ent 3 ent