Honeywell Galaxy Flex V3 Series Installer Manual page 235

Galaxy Flex Installer Manual
Setup menu
The TouchCenter has a number of configuration settings that are set up directly within the
keypad. To access these settings, the TouchCenter must be in communication with the panel
and the panel must be in Engineer mode. Proceed as follows:
From the home screen, press the SECURITY button, and then enter the Authorization
1.
code. This is the Engineer PIN of the control panel. The Security screen is displayed.
2. Press the MORE CHOICES button.
3. Press the SETUP button.
4. Press the TEST button.
From this screen, the following options are available:
Self Diagnostics
These three diagnostic tests are provided to verify correct operation of the TouchCenter and
to check the connection to the control panel:
LCD Display Test
Audio Test
LED Test
Address
If required, use the SERVICE option to change the RS485 address. If changed, reconfigure
the TouchCenter with the control panel.
TouchCenter operation
For general operation:
1. On the homepage, press the required function button.
Note: To program the control panel from the TouchCenter, press the Keypad Interface
button. The TouchCenter emulates a standard installer keypad.
2. Enter a valid PIN when requested.
3. Select the appropriate on-screen options. For help refer to the on-screen information
and to the separate user's guide.
You can set and unset the system by presenting a prox tag to the Proximity reader (see the
instructions in the help file on the home page).
Appendix G: Peripherals
235