Honeywell Galaxy Flex V3 Series Installer Manual page 45

Galaxy Flex Installer Manual
Press and again to toggle the display to show the status of the groups individually. To
#
move between each group, press
Press and again to return the keypad to the banner display.
#
Exit time
Once the setting routine starts, outputs programmed as Entry/Exit Horn emit a continuous
tone. The keypad used to set the system indicates the time remaining in seconds before the
system sets.
Exit time reset
Zones opened when setting starts or zones opened during the setting routine, cause the
sounder to pulse rapidly.
The number of open zones is displayed on the setting keypad. These zone types are not
listed: Final, Exit, Entry or Push-Set (and Secure Final or Part Final when acting as a Final).
Close open zones to reset and restart the exit time.
Omitted zones
Omitted zones are displayed on the keypad during setting. The keypad displays how many
zones are omitted.
Expiry warning
Outputs programmed as Entry/Exit Horn begin to pulse rapidly during the last 25% of the
programmed exit time.
System set indication
At the end of the exit time the entry/exit horns become silent for six seconds. This allows the
door to be locked and secured and gives the detectors time to settle before the system finally
sets. Two long tones are emitted to confirm that the system has set. If all groups are set the
keypad briefly displays the message SYSTEM IS SET before returning to the normal
banner.
Group logic setting restriction
If Setting Logic has been assigned to a group (refer to Setting Logic [63.1.2]), the set status
of the groups must satisfy the conditions defined in the option to permit the group to set. If
the Setting Logic conditions are not satisfied, then the group cannot set. If multiple groups
are being set simultaneously, but one group is restricted due to the programmed Setting
Logic, the remainder of the groups set. The restricted group does not set and no warning or
indication is given. A warning message is only given if none of the selected groups are
allowed to set.
and or and
A, B
08:58 TUE 22 NOV
A1U Group A1
group A1 is unset
Setting features
simultaneously.
45