Honeywell Galaxy Flex V3 Series Installer Manual page 239

Galaxy Flex Installer Manual
Configuration
4
Note: MAX readers can only be configured into the system from engineer mode.
1. Access engineer mode.
2. Check that Access Mode [69.1] is enabled.
3. Configure the reader as On-Line or Standalone using MAX Address [69.2.1]: 0=On-
Line, 1=Standalone (default).
4. Press . The panel may prompt for the AB line (1 – 4) that is to be searched; select
ent
the line and press
4
MAX readers are addressed as 8 (standalone) by default.
5. Only if adding a new MAX
prompts for the OPERATING MODE of MAX
1=Standalone as required and press
displays the current address of the MAX
4
new MAX address and press
addresses and the status of the reprogramming.
Note: We recommend addressing new readers with the lowest available number on
the line.
When reprogramming is complete the MAX
and the keypad display returns to 1=MAX Address.
6. Enter your engineer code, and then press
1 MOD. ADDED -
4
MAX reader switches on. Press
If this message is not displayed, the MAX
control panel and has not been configured into the system (LED 2 does not switch on).
4
The online MAX reader is now configured into the system.
Operating instructions
Opening the door without presenting a valid card activates a door forced alarm at the panel;
the buzzer sounds and LED 2 flashes until the door is closed.
Activating the egress switch allows the door to be opened without activating an alarm when
no card has been presented to the MAX
1. Ensure that LED 3 is on and all other LEDs are off.
2. Swipe the reader with a standard user or nightlock access user card. LED 3 switches off
and LED 2 switches on for the programmed Open Timeout.
3. Open the door while the LED 2 is on and access the area.
. The panel searches for the MAX
ent
4
reader: On locating the MAX
ent
. The keypad indicates the old and new MAX
ent
=CONTINUE is displayed on the keypad and LED 2 on the
esc
and the keypad returns to the unset banner.
esc
4
.
Appendix G: Peripherals
4
with the highest address. New
4
4
to be assigned: select 0=On-Line or
. When 0=On-Line mode is selected, the keypad
4
and the range of valid addresses. Enter the
4
bleeps, the LEDs on the MAX
to exit from engineer mode. The message
esc
4
reader is not communicating with the
address, the keypad
4
4
switch off
239