Connect The Battery And Mains Power; Initial Programming - Honeywell Galaxy Flex V3 Series Installer Manual

Galaxy Flex Installer Manual

Connect the battery and mains power

The control panel can accommodate one 10 Ah or one 17 Ah battery, depending on version.
Ensure that the battery connector leads on the control panel are connected to the correct
terminals on the battery.
WARNING: There is a risk of explosion if the battery is replaced by an incorrect
type. Dispose of used batteries according to the instructions.
1. Connect the battery as shown:
2. Connect mains power to the panel.

Initial programming

For instructions on how to use the keypad see Keypad/KeyProx operation on page 218.
After power is applied, wait 1 minute and the keypad displays the message:
This is followed by the message:
Connect the battery and mains power
Control panel Battery
−BAT −ve terminal
+BAT +ve terminal
Configuring
Please Wait
PRESS ANY KEY
TO SET UP
21