Honeywell Galaxy Flex V3 Series Installer Manual page 150

Communications [56]
period the panel will try to connect to network 1 again. The timeout range is 1 min to 7 days
(default 15 mins).
GPRS Line fail [56.3.2.2.3]
This option monitors the availability of the GPRS network. If the network is lost for an
extended period, a Line fail condition is generated.
GPRS IP Check Configuration [56.3.2.2.4]
Use this option to configure the IP check polling function. There are two options
1=Interval
2=Acknowledge
The IP Check signal is enabled and disabled within the ARC report programming. See
[56.1.2.1.5]
GSM/GPRS Network 1 [56.3.2.3]
GSM/GPRS Network 2 [56.3.2.4]
GSM/GPRS Network 3 [56.3.2.5]
Use this option to set up the GPRS network to which the module connects. By default this
uses the details from the SIM card where available. An APN may need to be programmed
manually for some networks
Note: Only enter data in this section if specific configuration is required.
Up to 3 networks can be specified manually. If data for multiple networks is entered the
system will attempt to use the best network for connection, with priority being given to
Network 1.
1=PLMN If this field is left blank the module will connect to the default network
identified by the SIM card. Use this field to force the module to connect to
a specific GSM network. Enter the Public Land Mobile Network (PLMN)
identification code for the specific network.
2=APN The Access Point Name for the GPRS provider; a maximum of 30
characters.
3=Login
The login (username) for the GPRS provider; a maximum of 20 characters.
4=Password
The password for the GPRS provider; a maximum of 20 characters.
5=Centre No.
This is the SMS Centre number.If you enter data here it will overwrite the
default centre number in the SIM card
6=Connection Use this sub-option to set the GPRS network connection (1=Continuous
(the default), 2=Timeout).
150
This sets the Frequencey of the polls in hours and minutes
This defines if the system should expect an acknowledgement reply
from the receiver. If enabled, the system will report failure of the IP
Check in the diagnostic log if it does not get an acknowledgement.
Galaxy Flex Installer Manual