Honeywell Galaxy Flex V3 Series Installer Manual page 142

Communications [56]
Receiver Destination [56.1.1.receiver.path.1] (excluding USB)
Enter a phone number for PSTN and GSM, and enter an IP address for GPRS and Ethernet.
If configuring GPRS or Ethernet, after entering the IP address, press
Port No.
Receiver Format [56.1.1.receiver.path.2]
Receiver Format [56.1.1.receiver.path.1] (USB only)
Each of these comms devices can be setup for one of the following signalling formats:
PSTN (DTMF, SIA, Microtech, Contact ID, SMS)
GSM (DTMF, SIA, Microtech, Contact ID, SMS)
GPRS (SIA, Microtech)
Ethernet (SIA, Microtech)
USB (Microtech)
Select a format suitable for the receiver type use at the ARC.
Note: The alarm signalling priorities for SIA and Microtech formats are: 1. Fire, 2. Duress,
3. Silent panic, 4. Panic alarm, 5. Security, 6. Intruder, 7. Other alarms, 8. Events, 9.
Audio. In other formats, events are sent chronologically.
DTMF [56.1.1.receiver.path.2.1] (PSTN, GSM)
DTMF format provides a means of reporting alarm and status messages via PSTN and GSM
networks. Each transmission reports the state of 8 reporting channels, which can be
individually configured to report different alarm, fault or state conditions.
Note: DTMF reporting is incompatible with other reporting formats and cannot be used
within the same reporting sequence. A specific reporting sequence is provided for
DTMF receivers [56.1.2.5.3]. DTMF receivers that are included within the ARC or
AUX reporting sequences will not be used in those sequences.
It is possible to use both ARC/AUX and DTMF sequences in parallel, providing the DTMF
sequence includes only DTMF receivers, and the ARC/AUX sequences include only non-
DTMF receivers.
SIA [56.1.1.receiver.path.2.2] (PSTN, GSM)
SIA [56.1.1.receiver.path.2.1] (GPRS, Ethernet)
The SIA (Security Industries Association) format is a protocol that transmits detailed
information, including zone descriptions, to a computer with suitable software or to an SIA
compatible receiver. The SIA format is capable of transmitting over 330 different events
(refer to Appendix B for further details).
On selecting the SIA format, you are prompted for the required SIA level. There are four
SIA levels available:
0 (default) – Basic event information with 4 digit account number.
142
Galaxy Flex Installer Manual
to configure the
ent