Honeywell Galaxy Flex V3 Series Installer Manual page 191

Galaxy Flex Installer Manual
Note: Each DCM card can be assigned a single menu function (refer to Codes [42]).
Activating this function with a card that is assigned to all groups on a reader that is
only assigned to a single group, results in the function operating on all of the card's
groups. The DCM function is not restricted to the groups assigned to the reader; it is
restricted to the groups assigned to the card, as long as there is one group common
to both. This means that a DCM reader assigned only to group 1, for example, can
be used to activate the DCM reader function on groups 1, 2, 3 and 4 by a card with
all of these groups allocated. The groups are assigned to the DCM card using Codes
[42].
DCM Emergencies [69.3.1.5.05]
Use this option to configure each individual DCM reader to respond to fire zones in a given
set of groups. When a fire zone in one of the groups allocated to the reader is opened, the
reader triggers the door strike and holds the door open until the system is reset. The DCM
LED lights and the buzzer sounds. Closing the fire zone has no effect - the DCM readers are
treated as latched outputs and an appropriate reset is required.
A second group map is allocated to each DCM reader in order to facilitate this function.
This permits the existing door control features to be separate from the fire escape features.
The default setting for each DCM reader is all groups selected. Therefore, a system, which is
unchanged from the default, opens all DCM doors in response to any fire zone activation.
Select the Emergencies option to select the groups you want allocated to the DCM readers
for escape purposes. When a fire zone is activated in any of the programmed groups, the
door controlled by the DCM is opened.
DCM Security Nightlock [69.3.1.5.06.1]
This allows a time schedule to be allocated to determine when access to the door will be
blocked. Up to 4 weekly time schedules can be programmed. Setting the schedule to 00
disables the function.
DCM Security Unlock Time [69.3.1.5.06.2]
This allows a time schedule to be allocated to determine when the door will be unlocked to
provide unrestricted access. Up to 4 weekly time schedules can be programmed, depending
on model (see Table 1 on page 11). Setting the schedule to 00 disables the function.
Access Control [69]
191