Honeywell Galaxy Flex V3 Series Installer Manual page 101

Galaxy Flex Installer Manual
SWDC Set Dly [51.70]
Enable this parameter to delay the indication of open zones at the start of a set sequence
while latching sensors are being reset. This affects indication via keypad text and sounders.
If there are no outputs programmed as Switch DC (function 08), there is no delay at the start
of the set sequence.
MF BL Enable [51.71]
Enable this option to send an SIA event if the battery is low and there is a mains power
failure. When the event is sent, the Power Delay time set in parameter 51.20 stops
immediately.
Max Alm Cause [51.72]
Use this option to define the range of valid cause codes agreed with the Alarm Receiving
Centre. When this function is enabled, a cause code must be entered by the user to perform a
system reset. To disable, set the alarm cause code to 000.
Guard Unset [51.73]
Enable this option to allow a type 1 user code to unset the system if an alarm has occurred.
This gives the type 1 user 60 minutes to check for the cause of the alarm and set the system.
Once the system is set the type 1 user can no longer unset it.
MAX LEDs off [51.76]
0=Disabled LEDs are on regardless of group set state.
1=Enabled Turns the MAX LEDs off in the set state (on a MAX
the Set state).
Duress User [51.77]
Use this option to allow duress to be added to a user's attributes.
0=Disabled, 1=Enabled.
Entry Time 2 [51.78]
This option is similar to Entry Time [51.05] but only affects zones programmed with the
function 45 ALT Entry.
The range is 0 to 300 s and the default is 45 s.
Camera PIR [51.79]
Use this option to simultaneously configure all wired camera devices. If you want to
configure a single camera device only, use menu option [52.4.zone.15] instead.
01=LED Mode
02=Pulse Count
0=Off (default), 1=On. Defines if the LED indicates detection.
This option defines the pulse count before alarm activation (1 to 4).
Parameters [51]
4
, LED 1 remains on in
101