Honeywell Galaxy Flex V3 Series Installer Manual page 100

Parameters [51]
Lockout Tamper [51.62.2]
Use this option to set the number of invalid code attempts that can be made before system
tamper occurs.
The default is 15 and the range is 0 to 21. 0 disables the function.
Banner Alerts [51.63]
Use this option to program whether system alerts are displayed on the keypad banner. If
enabled, system events are indicated on the display. The default setting is disabled.
Set Override [51.64]
Use this option to change the type of user that can override specific fault events to set the
system. A different value can be programmed for each group.
Reset levels [51.65]
This parameter determines the type of user that can reset specific fault types.
Note: This parameter affects and is affected by parameters 51.06 (System Reset), 51.07
(Tamper Reset) and 51.22 (PA Reset). If the parameter reset level is changed at
51.65 it is reflected at 51.06, 51.07 and 51.22.
Min PIN Size [51.66]
Use this option to set the minimum size of each user code. This can be set from four to six
digits. The default is four digits.
[51.67] Not used
Line Fail [51.68]
Use this option to program the period between the panel being alerted by a communication
module of a Line Fail condition and the user being alerted of the alarm condition.
The default is 50 seconds and the range is 0 to 1800 seconds.
Note: The communication module may take up to 40 seconds to alert the panel of a Line
Fail condition. This time is in addition to the programmed time of 0 to 1800
seconds.
This parameter affects all communication modules on the system.
Alert Inds [51.69]
Use this option to switch off the audio alert indication.
0=No Indication
1=Audio Only (default setting)
2=Visual Only (only when parameter 63 enabled)
3=Audio/Visual (only when parameter 63 enabled)
100
Galaxy Flex Installer Manual