Honeywell Galaxy Flex V3 Series Installer Manual page 65

Galaxy Flex Installer Manual
To control the menu options available to each user level refer to Menu Access [68]. You
can allow users to access menu options that their code types are not, by default, authorized
to access.
Modify Name [42.1.User code.3]
Use this option to assign a name to a user with a maximum of 6 alpha-numeric characters.
The default user name is USER. The engineer (ENG) and manager (MGR) are fixed and
cannot be reprogrammed.
To add or modify a user name:
1. Press to erase the characters of the default or previous name.
2. Using or , navigate to the first character of the name, and then press
A B
selected character appears on the top line.
Press to move between upper and lower case characters, and the system library. Enter
#
a character, or word reference number, to access alpha-numeric characters and library
words (see Appendix A: Library).
3. Continue this process until the name is completed.
4. Press to store the name and return to the previous menu level.
esc
Schedule [42.1.User code.4]
Use this option to enable a user to access the menu options for setting and unsetting. The
PIN code only operates during the OFF period of an assigned weekly schedule that is
created in option 65.1.
If a user attempts to use his PIN code during the ON periods of his assigned schedule, then
an illegal code event is logged and any outputs programmed as illegal code are activated.
Setting this option to 00=None means that PIN codes are always operational.
Note: This option does not control card access through doors. This is controlled by
templates and is allocated to a user in Template [42.1.User code.9].
Modify Group [42.1.User code.5]
Use this option to select the system groups that the user has access to and operational control
over. The Modify Groups option is only available when group mode is enabled (refer to
Groups [63.1]). The system defaults to groups disabled.
When you select the Modify Groups option, the groups currently allocated to the user are
displayed. All users default to group 1.
Pressing the group number toggles the group assigned to the user. Pressing 2 and 3 assigns
groups 2 and 3 to the user. Pressing 1 (when group 1 is already assigned) removes group 1
from the user code.
To assign group choice to the user, press . When the required groups have been assigned to
the user, press to accept the programming and return to the previous menu level.
ent
Codes [42, Quick Menu 7]
ent
. The
65