Ac Power And Backup Battery - Honeywell ADEMCO LYNXR-ISIA Installation And Setup Manual

Table of Contents

Advertisement

The system is powered by a 9VAC, 25VA Plug-in Transformer, ADEMCO K10145X10. Refer to the wiring
table below for wire gauge and length.
Use only the provided ADEMCO K10145X10
Transformer.
Wiring to the AC Transformer must not exceed 300 feet using 16-gauge wire. The voltage reading
between terminals 15 and 16 of the control must not fall below 9.00VAC.
Do not plug the transformer into the AC outlet until after all wiring connections have been made.
Backup battery
In the event of an AC power loss, the system is supported by a long life backup battery that is supervised for
connection and for low voltage conditions. If the battery is missing, or a low battery condition is detected, a
"low battery" message is displayed and a report is sent to the central station. In addition, the system will beep
once every 45 seconds to audibly indicate a low battery condition (press any key to stop the beeping).
AC Power and Rechargeable Backup Battery
Connecting AC Power and backup battery
1. Connect wires from the K10145X10 AC Transformer to
terminals 15 and 16 as shown in the wiring diagram.
2. Remove battery retainer.
3. Peel the backing from tape on the back plate.
4. Insert battery pack into back plate.
5. Install battery retainer.
6. Connect battery connector to receptacle on terminal
block PC board.
7. After all wiring connections have been made, snap the
front assembly to the back plate and plug the
transformer into a 24-hour, 110VAC unswitched outlet.
Note: Rechargeable batteries may take up to 48-hours to
fully charge. The "LOW BAT" message should clear
within four hours or by entering Test Mode.
Ensure the cover is snapped closed prior to applying AC power.
LYNXR-ISIA Installation and Setup Guide

AC Power and Backup Battery

Distance from Transformer
Up to 75 feet
75 to 150 feet
150 to 300 feet
BATTERY
PACK
BATTERY
RECEPTACLE
- 11 -
to Control
RETAINER
BATTERY PACK SHOWN
TAPE
WIRING
TERMINALS
Wire Gauge
#20
#18
#16
NOTE
LYNXRCHKIT-HC
07000-007-V0

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents