Ac Power And Backup Battery - Honeywell Lynx Plus Series Installation And Setup Manual

Honeywell lynx plus series security systems

Hide thumbs Also See for Lynx Plus Series:

User manual (64 pages)

Programming manual (24 pages)

Quick manual to user functions (2 pages)

Table Of Contents

Table of Contents

The system is powered by a 9VAC, 25VA Plug-in Transformer, K10145WH or K10145X10 (K10145CN in

Canada). Refer to the wiring table below for wire gauge and length.

Distance between

Transformer and Control

Up to 75 feet

75 to 150 feet

150 to 300 feet

Use only the provided ADEMCO K10145WH/K10145X10 or K10145CN Transformer. Wiring to the AC

Transformer must not exceed 300 feet using 16-gauge wire. The voltage reading between terminals 10 and

11 of the control must not fall below 9.00VAC.

Do not plug the transformer into the AC outlet until after all wiring connections have been made. Ensure the

cover is snapped closed prior to applying AC power

Backup battery

In the event of an AC power loss, the system is supported by a long life backup battery that is supervised for

connection and for low voltage conditions. If the battery is missing, or a low battery condition is detected, a

"low battery" message is displayed and a report is sent to the central station. In addition, the system will beep

once every 45 seconds to audibly indicate a low battery condition (press any key to stop the beeping).

AC Power and Rechargeable Backup Battery

Connecting AC Power and backup battery

Connect wires from the K10145WH or K10145X10 (K10145CN in Canada) AC Transformer to terminals 10 and 11 as

shown on the summary of connections diagram.

Remove battery retainer.

Insert battery pack into back plate.

Install battery retainer.

Secure battery retainer with the provided screw.

Connect battery pack connector to the receptacle on the PC board.

After all wiring connections have been made, snap the case closed and plug the transformer into a 24-hour, 110VAC

unswitched outlet.

Note: Rechargeable batteries may take up to 48-hours to fully charge. The "LOW BAT" message should clear within four

hours or by entering Test Mode.

Wire Gauge

#20

#18

#16

SCREW

Lynx Plus Series Installation and Setup Guide