Abbott CELL-DYN 3200 System Operator's Manual page 83

Section 2
1 Left Front Cover
2 Right Front Cover
3 Touch Plate
4 Phillips-head Screws
5 Sample Loader
6 Tower Cover
Figure 2.2 Analyzer Front Covers — SL Model
Open Left Front Cover
Open Right Front Cover
Remove Tower Cover
Remove Front Skirt
CELL-DYN 3200 System Operator's Manual
®
9140181K—July 2002
1
6
5
To open the Left Front Cover on both the SL and CS models, gently pull on the
hand hold to release it. Swing the cover all the way to the left to completely expose
the left side of the Flow Panel.
To open the Right Front Cover on both the SL and CS models, gently pull on the
hand hold to release it. Swing the cover all the way to the right to completely
expose the right side of the Flow Panel. Because of the attached Touch Plate and
Status Panel, this cover should not be removed from the instrument.
To remove the Tower Cover on both the SL and CS (tower door on the CS model
must be open) models, rotate tower away from front panel using hand hold. Lift
bottom of cover off skirt locating pins and gently pull the top of the cover away
from the analyzer.
To remove the Front Skirt Cover on the CS model, remove the four Phillips-head
screws, two on either side of the instrument, which hold the skirt to the instrument
frame. Pull the skirt away from the instrument.
Installation Procedures and Special Requirements
2
3
4
2-7