Abbott CELL-DYN 3200 System Operator's Manual page 196

Operating Instructions
Set Up Instructions
5-44
NOTE: Auto-transmitting extended data uses CPU time during the acquisition
cycle. In order to reduce the time taken by this transmission, auto-
transmission of extended data is only allowed at the baud rates of 38400 and
56000. If there is a need to re-transmit data, this can be done one specimen
at a time from the DISPLAY SPECIMEN menu if the correct baud rate has
been selected and transmission of either extended histograms or extended
scatter plots has been selected.
Computer Set Up Procedure
1. From the OPERATION SET UP MENU, press [COMPUTER SET UP] to display
the COMPUTER SET UP screen.
2. For the first five options on the list, use the Arrow keys on the keyboard to
move the cursor to the desired selection and press [TOGGLE ON/OFF] to enable
or disable the selection.
NOTE: The [TOGGLE ON/OFF] key is displayed when the cursor is
positioned in any of the first five entry fields.
3. For the last five options on the list, type the appropriate information and press
the Enter key on the keyboard to save the entry and advance the cursor.
4. When all the information has been entered, press [REINIT INTERFACE] to
initialize the interface for the selected configuration.
5. If desired, press the Print Screen key on the keyboard to obtain a printout of
the configuration.
6. Press [SET UP] to return to the OPERATION SET UP MENU screen.
7. Press [RETURN] to return to the SET UP MENU.
Section 5
CELL-DYN 3200 System Operator's Manual
®
9140181K—July 2002