Abbott CELL-DYN 3200 System Operator's Manual page 259

Section 5
Work List Menu
Work List
CELL-DYN ® 3200 System Operator's Manual
9140181H—October 2001
CS Model — Closed Mode
In the CS Closed Mode, the Work List is searched after each tube bar code is read
(the RUN cycle has begun). Work List entries are matched using one of the
following three methods:
1. Bar Codes on the sample tubes (for Bar Code Reader).
2. Bar Codes entered into the <Next ID> field of the RUN screen by the operator.
3. Non-Bar Code Specimen IDs entered into the <Next ID> field on the RUN
screen by the operator.
SL Model — Open Mode
In the SL Open Mode, the Work List is searched as soon as the operator enters a
bar code number or non-bar code Specimen ID in the <Next ID> field and presses
the Enter key. If a match is found, the demographic information is immediately
displayed on the RUN screen. This will occur even if the Touch Plate is not pressed.
Work List entries are matched using one of the following two methods:
1. Bar Codes entered into the <Next ID> field of the RUN screen by the operator.
2. Non-Bar Code Specimen IDs entered into the <Next ID> field on the RUN
screen by the operator.
CS Model — Open Mode
In the CS Open Mode, the Work List is searched as soon as the operator enters a
bar code number or non-bar code Specimen ID in the <Next ID> field and presses
the Enter key. If a match is found, the demographic information is immediately
displayed on the RUN screen. This will occur even if the Touch Plate is not pressed.
Work List entries are matched using one of the following two methods:
1. Bar Codes entered into the <Next ID> field of the RUN screen by the operator.
2. Non-Bar Code Specimen IDs entered into the <Next ID> field on the RUN
screen by the operator.
The [WORK LIST] key is displayed on the RUN screen. The WORK LIST screen and
the following soft key labels are displayed when the [WORK LIST] key is pressed:
INSERT/DELETE
DELETE ALL
WORK LIST SET UP
PRINT WORK LIST
RETURN
Operating Instructions
5-107