Abbott CELL-DYN 3200 System Operator's Manual page 66

Use or Function
System Components
Line Frequency and Line Voltage Select Switches
1 Line Voltage Select
Switch
2 Line Frequency Select
Switch
3 Main Power
Connector
4 Fuse
Figure 1.9 Power Supply Module
Main Power Connector
Fuse
1-18
These switches are used to select the Line Frequency and Voltage for the Analyzer
(refer to Figure 1.9).
WARNING: SET FOR 120 VOLTS
When operation at other line voltage is required,
refer to Operator's Manual for detailed instructions.
WARNING: These switches are set at the factory for 120 volts. When operation at
other line voltage is required, refer to Figure 1.9.
2
This receptacle is used to connect the main power cord to the instrument.
An 8-amp (110/120 V) T (Slo-Blo) or 4-amp (220/240 V) T (Slo-Blo) Fuse
protects the Analyzer from electrical spikes.
PN 9230003E
1
CELL-DYN 3200 System Operator's Manual
®
9140181K—July 2002
Section 1
4
3