Abbott CELL-DYN 3200 System Operator's Manual page 277

Section 5
Introduction
Scrolling Through the Data Log
DATA LOG Menu
CELL-DYN ® 3200 System Operator's Manual
9140181H—October 2001
The Data Log stores all data and demographic information in a log format for the
last 10,000 cycles run on the CELL-DYN 3200. The record information is stored
chronologically by sequence number. Scattergrams and histograms are stored for
all 10,000 records.
NOTE: When the log is full, subsequent entries cause the oldest entry to be
deleted and the remaining entries to move up one line, so that the current
records are added to the bottom of the list.
The first part of this section gives a brief description of the DATA LOG menu keys.
The Data Log Set Up portion gives instructions for customizing the display and
printout of the Data Log. The final section gives instructions for data review from
the Data Log.
Each screen display (page) may contain up to 18 specimens.
Use the Left and Right Arrow keys to scroll through the complete list of parameters
for all specimens displayed on a page. Use the Up and Down Arrow keys to move
the cursor between specimens on a page.
Use the Page Up key to scroll through preceding pages. Use the Page Down key to
scroll through succeeding pages.
The function of each of the soft keys in the DATA LOG menu, shown in Figure 5.44,
is discussed in this section.
The Data Log consists of 5 pages (screens). The first page contains limited
demographic data on the patient, and subsequent pages display parameter results.
The following data is common to all 5 screens:
1. Sequence #
2. Specimen ID
3. Collection Date and Time
4. Operator ID
The second page displays the results for the WBC Parameters. The third page
displays the results for the RBC parameters. The fourth page displays the results
for the PLT parameters. The fifth page displays the results for the WBC parameters
expressed as a percent.
Operating Instructions
Using The Data Log
5-125