Figure 6-13 Auto Discovery Window - Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual

C O N F I G U R I N G M A X P R O N V R
6
Configuring the Cameras
Figure 6-13
To configure the Auto Discovery Settings
Note:
136
Auto Discovery Window
• On the Camera page, click the Auto Discovery button, the Auto Discovery screen
appears. Perform the following:
• Under Select the IP Address range for discovery, type and set the IP address
in From and To fields.
• Under Settings, select "NTSC" or "PAL" from Video Format list.
• Under Set camera credentials
• Type a Username for the camera.
• Type a Password for the camera.
You cannot edit the Camera Type field. The cameras credentials settings
provides the username and password for Honeywell (for models already added in
NVR database), AXIS (for models already added in NVR database) and ONVIF
cameras discovery and addition. If a Honeywell or AXIS ONVIF model that is not
already added in NVR database is discovered, then the camera credentials set for
ONVIF is used for discovery and addition. You can find all the models that are
already added in NVR database by checking the models listed in the Camera
Type drop-down in the Camera tab.
• Click Apply to save the changes or click Reset to clear the information entered.
The username and password entered is applicable for all NTSC or PAL cameras.
However, the username and password can be changed while configuring a
particular camera.
MAXPRO NVR 5.0 Installation and Configuration Guide