Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual page 153

Adding Arecont 360/180 Camera
MAXPRO NVR 5.0 Installation and Configuration Guide
Note:
Depending on the mounting position, the Axis 360/180 camera (this does not
apply to AXIS multi-imager cameras) supports eight or less video streams with
one stream per channel added. Each channel added consumes 1 channel
license. For Encoders if you add 4 channels then it will consumes 1 channel
license.
By default, the Axis 360/180 camera adds eight channels under camera list
covering below views. Views which are not required for your specific application
can be deleted. To reclaim the used channel license, select the specific channel
in the list and then click Delete.
1. Overview: A non-dewarped 360° view
2. Panorama: One dewarped 180° panoramic view
3. Double Panorama: Two dewarped 180° panoramic views (Not available when
the camera is mounted on a wall)
4. Quad View: Four dewarped 90° views, one for each direction (Not available
when the camera is mounted on a wall)
5. View Area 1: A dewarped 90° view with PTZ (pan/tilt/zoom) functionality
6. View Area 2: A dewarped 90° view with PTZ (pan/tilt/zoom) functionality
7. View Area 3: A dewarped 90° view with PTZ (pan/tilt/zoom) functionality
8. View Area 4: A dewarped 90° view with PTZ (pan/tilt/zoom) functionality
To add Arecont 360/180 Camera in MAXPRO NVR
Note:
• v3.1 SP1 or later supports discovering and adding certain Arecont 360/180
model cameras. These were supported through RTSP only in v3.1 or lower
versions.
• For multi-channel encoders and multi-imager 180/360 cameras with single IP ,
only one channel license is consumed. Maximum System limit is 64 cameras
including, the cameras connected through encoders and the
cameras/streams connected from the multi-imager is 180/360 cameras.
1. In MAXPRO NVR, click the Configurator tab. The System page displays by default.
2. Click the Camera tab to open the Camera page.
3. Click Auto Discovery button. The Auto Discovery screen is displayed and the discovery
starts by default. If discovery is stopped then click Start Discovery to discover the
cameras in the network. The cameras are added based on the IP range and Video Format
settings. See the Configuring the Auto Discovery Settings
information.
4. After the discovery, to add the Arecont 360/180 camera models, select the check boxes
corresponding to Arecont 360/180 camera models as shown in
Note:
Arecont 360/180 cameras are listed in the discovery pane with their model
numbers for example AV8365DN-F8.
C O N F I G U R I N G M A X P R O N V R
Configuring the Cameras
section on page 135 for more
Figure 6-28.
153