C O N F I G U R I N G M A X P R O N V R
6
Configuring the Cameras
Note:
Note:
134
Only HFD6GR1, HSW2G1, HCD8G, HBD8GR1, H4D8GR1, HDZ302DE, HDZ302D
and HDZ302DIN model cameras support H.265 Codec type.
•
Compression Level - The Compression Level is defaulted to "Medium". You can
select a new Compression ratio as applicable.
•
GOP - The GOP is defaulted to "5". Type a new GOP as applicable. Group of
Pictures (GOP) are individual frames (number of pictures) that are grouped together
and played back for viewing. A GOP consists of "IFrame" picture type that represents
a fixed image independent of other picture types. Each GOP begins with this type of
picture.
•
Video Format - Select the Video Format (NTSC or PAL). The NTSC and PAL are the
widely used video formats.
•
Streaming Mode - The Streaming Mode is defaulted to UDP. You can select TCP
streaming mode as applicable. The Streaming Mode is supported only for specific
models of Honeywell, AXIS and ONVIF Cameras.
•
Continuous - Select the FPS for Continuous recording.
•
Event - Select the FPS for Event based recording.
Live/Recording Quality can be varied by controlling GOP . The formula for this is calculated
as follows: Recording Quality resulting FPS = Live FPS/(GOP*I Frame Number for
recording).
For example, in the following table if Live FPS is configured as "30" and Continuous
recording is set to record "Every I frame" and Event recording is set to "Same as Live" with
GOP value set to "5", the result is 6 FPS continuous recording quality and 30 FPS event
recording quality.
GOP value below 5 may not be achieved from all the cameras.
•
Enable Edge Sync- This option is supported for Profile-G compliant cameras and
used for checking whether the camera is really Profile-G compliant. Click the Get
Configuration button, if the camera is a Profile-G compliant camera then the Get
Configuration button disappears and Enable Edge Sync check box is enabled.
Select the check box and then Sync/view the recordings using Edge Sync Settings
option from the Systems tab.
If the camera is not Profile-G compliant then NVR application displays Edge Sync
not supported or enabled for this device message at the bottom.
MAXPRO NVR 5.0 Installation and Configuration Guide