Configuring Loitering & Intrusion Trace Alarms; Figure B-6 Upgrade Firmware - Setup Page - Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual

A P P E N D I X B
B
Event and Alarm Types
Configuring Loitering & Intrusion Trace Alarms
H4L6GR2 and HBL6GR2 camera models support both Intrusion Trace and Loitering Trace
Alarms. User needs to configure these alarms in specific camera web page. You need to first
upgrade the firmware of the camera and then configure the alarms.
How to upgrade the Fi rmwar e of a camera
1.
2.
3.
Figure B-6
4.
How to confi gure Loi ter ing Trace Alarm
Note:
Tip: The below procedure is also applicable to configure the Intrusion Trace Alarms.
1.
338
Launch the required camera web page.
Click the Setup tab.
On the left pane, navigate to System Setup > Upgrade. The Upgrade page is displayed
as shown below.
Upgrade Firmware - Setup Page
Click Import to import the Latest Firmware file and then click Upgrade.
You can configure and use only one alarm license at once. If you want to view
another type of alarm then uninstall the previous firmware, install the required
firmware and then configure the alarm.
After the camera firmware upgrade is done, in the camera web page navigate to Video
Analytics > Smart Plan. The Smart Plan page is displayed on the left side as shown
below.
MAXPRO NVR 5.0 Installation and Configuration Guide