Figure 6-38 Camera Properties Pane; Configuring The Input And Output For An Analog Camera - Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual

Configuring the Input and Output for an Analog Camera

MAXPRO NVR 5.0 Installation and Configuration Guide
2. Click on the left corner to open the camera properties pane see
Figure 6-38 Camera properties pane
3. Under General > PTZ > PTZ Settings
• Device Type - Select the camera as a PTZ camera. The PTZ settings are displayed.
• Select the PTZ Protocol. Available PTZ Protocol options are VCL, Pelco P, Pelco D,
Maxpro, GE Kalatel.
Note:
Vicon protocol is not supported in this release.
• Select the required Baud Rate. Available Baud Rates options are 110, 300,600,
1200, 2400, 4800, 9600, 14400, 19200, 38400, 56000, 57600, 115200, 128000,
256000.
• Select the Parity. Available Parity options are ODD and EVEN
• Type the Hardware ID, if the analog camera type is a PTZ camera. The hardware ID
is based on the PTZ Protocol.
• Select the PTZ Sensitivity for a PTZ camera. Available PTZ options are: Low,
Normal, High and Maximum.
• Select the COM Port name. Available COM Port names options are COM 1 and
NONE For Hybrid PE, COM Port names are COM1, COM2, COM3, COM4 and
NONE. Select COM 4 for analog PTZ control.
• Select the Stop Bits. Available stop bits options are 1 and 2.
• Select the Data Bits. Available data bits options are 7 and 8.
4. Click Save.
The input and output hardware configuration for an analog camera in MAXPRO NVR Hybrid is
configured by default and when you add an analog camera, then by default the camera is
C O N F I G U R I N G M A X P R O N V R
Configuring the Cameras
Figure 6-12.
165