Figure 6-2 Camera Discovery Page; Figure 6-3 Discovered Cameras - Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual

MAXPRO NVR 5.0 Installation and Configuration Guide
Configuring the Honeywell cameras with MAXPRO NVR Wizard
Note:
Click RESET to restore the default settings for each of the fields listed in the
above table.
2. Step 2 - The CAMERA DISCOVERY page
Figure 6-2 CAMERA DISCOVERY page
• All the settings that you have saved on the CONFIGURATION page are listed, along
with the discovered cameras. As each connected camera is discovered (notice the
message that displays on the lower right of your monitor) it is added to the list. This
list disappears as the cameras are added to the MAXPRO NVR software.
Figure 6-3 Discovered Cameras
Note:
The ADD button on the CAMERA DISCOVERY page appears only if you have
selected "NO" corresponding to Auto Add Discovered Camera in the
CONFIGURATION page. Select the check boxes corresponding to a camera
from the discovered list, and then click ADD button to add the discovered
cameras of your choice to the MAXPRO NVR software.
• A MAXPRO NVR Wizard pop-up message appears detailing the available free
channels in the system on NVR Hybrid units if there are analog cameras (pre-
configured or added manually). It also gives you a hint about deleting the unused
analog channels to add IP cameras. Click OK to continue.
C O N F I G U R I N G M A X P R O N V R
(Figure 6-2) appears.
113