Patches Released On Top Of Nvr 4.0; Skylake Patch - Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual

Appendix C

Patches Released on Top of NVR 4.0

This chapter lists the various patches that are released on top of MAXPRO NVR 4.0. It also
explains the enhancements that you can experience after installing the specific patch.
In this chapter...
AX IS Pa tch
Patch Version: (Build 87H_T2 patch)
Installation: To be installed on top of MAXPRO NVR 4.0
ISSU ES FIXED
The following are the issues fixed in this patch:
Skyl ake Pat ch
Patch Version: (NVR 4.0 SP1 Build 97)
Installation: To be installed on top of MAXPRO NVR 4.0
R E L E A S E H I G H L I G H T S :
This Patch includes the following enhancements:
1.
2.
MAXPRO NVR 5.0 Installation and Configuration Guide
Section
AXIS Patch

Skylake Patch

• AXIS camera stops responding after upgrading the firmware version to 6.30.1. This
issues is fixed by providing AXIS new Firmware support 6.XXXX.
• Fixed the SMART VMD Issue: Recording is not in progress for the cameras which are
configured only for motion based recording. However, motion based alarms are
generated.
Supports Sky-Lake Processor
For Archival under Delete Archived Recordings After > Continuous recording drop-
down, new deletion schedules are implemented such as 2,3,4 and 5 years as highlighted
below.
See page...
331
331
C
349