Maxpro®Nvrs - Axis Camera/Encoders Discovery And Configuration (Using Onvif); Step 1: Enable Onvif Web Service On Axis Camera/Encoder; Figure B-15 Loiter Trace - Live View Logs - Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual

Step 1: Enable ONVIF Web Service on AXIS
Camera/Encoder
Scenario Description
MAXPRO NVR 5.0 Installation and Configuration Guide
MAXPRO®NVRs - AXIS Camera/Encoders Discovery and Configuration (using ONVIF)
Figure B-15 Loiter Trace - Live View Logs
MAXPRO®NVRs - AXIS Camera/Encoders
Discovery and Configuration (using ONVIF)
This section describes the steps to discover and configure the AXIS Camera/Encoders as an
ONVIF device in MAXPRO NVRs.
If you have questions concerning this document, please contact Honeywell Technical
Support. See the back cover for contact information.
If you are unable to discover AXIS cameras/encoders using ONVIF compliance standard in
MAXPRO® NVR, ensure that ONVIF Web service is enabled and set up on the AXIS device.
The above scenario is noticed if you log on to the camera web page (for example to set the IP
address on the AXIS device) prior to discovering and configuring the device in NVR through
ONVIF; as a result the ONVIF Webservice gets disabled automatically.
Perform the steps in Option 1: Add a ONVIF user in the camera web page.
325. or Option 2: Reset to factory default settings
the AXIS devices.
Note:
AXIS P1347 Network Camera is used as an example to show the steps required.
Perform similar steps for other AXIS ONVIF devices.
Option 1: Add a ONVIF user in the camera web page.
A P P E N D I X B
section on page
section on page 327 to enable ONVIF on
343