Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual page 132

C O N F I G U R I N G M A X P R O N V R
6
Configuring the Cameras
Note:
Caution:
Note:
Note:
132
If Camera Type is OnCam Grandeye Fisheye (OnCam-GE-***-Fisheye), the 360
Settings tab does not display Enable Panamorph, Immervision settings and
shows Enable Dewarping, OnCam Grandeye settings.
• Enable Panamorph: Select the Enable Panomorph check box to enable the
Panomorph feature.
• Mounting position: Select the Mounting Position. You have three options to
choose from: Wall, Ceiling, and Ground.
• Modes: Select the Mode for the camera. The available modes are PTZ Mode,
Quad Mode, and Perimeter Mode. The default mode is PTZ Mode
• Lens ID: Select the Lens ID for the camera. The supported lens ids from v3.5 or
later are A0**V, A0IFV, A0NKV, A1UST, A8TRT, B0QQV, B4QQV, B5SST,
B6SST and B8QQT. By default AO**V Lens
Only Immervision certified camera models can support this feature
enabled. Before configuring this feature, please check whether your
camera has the Panomorph lens.
• To view live video from Immervision certified cameras, Refer Video Viewing
Options from Immervision Enabled Cameras section in
Operator's Guide.
• The recommended Aspect Ratio for Immervision Certified cameras is 4:3.
• Enable Dewarping: Select the Enable Dewarping check box to enable the
dewarping feature for OnCam Grandeye fisheye cameras.
• Mounting position: Select the Mounting Position. You have three options to
choose from: Wall, Ceiling, and Ground.
• Modes: Select the Mode for the camera. The available modes are Virtual
camera view, Panorama 2x180 views, Panorama 1x360 view and Panorama
1x180 view.
To view live video from OnCam Grandeye cameras, Refer Video Viewing Options
from OnCam Grandeye Cameras section in
MAXPRO NVR
MAXPRO NVR Operator's
MAXPRO NVR 5.0 Installation and Configuration Guide
Guide.