Figure 6-17 Encoder Discovery; Discovering And Adding Multi-Channel Encoders - Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual

Discovering and Adding Multi-channel Encoders

MAXPRO NVR 5.0 Installation and Configuration Guide
Note:
Manual addition is recommended only when auto discovery is not supported in
case of camera/encoder streaming across subnets.
1. Click Manual Add. A new camera is added in the camera pane.
• From the Camera Type drop-down list, select the required ONVIF DEVICE (for
cameras) or ONVIF 1/4/8/16 CHANNEL ENCODER DEVICE (for encoders) option.
2. Type the Camera Name and IP Address.
3. Type the User Name and Password of the ONVIF device.
4. Under camera properties pane, configure the General and Primary Stream settings.
Note:
For streaming to start, the (Resolution and FPS) in camera properties pane
should be set to match the values supported by the camera/encoder.
5. Click Save.
An Encoder connects to an analog camera using a coaxial cable and converts analog video
streams to digital video streams, which can be sent over an IP network. Multistream or Dual
stream is not supported for encorders.
Each encoder varies based on the number of channels (cameras) supported. Please visit
URL: http://www.security.honeywell.com/hota/
supported by MAXPRO NVR.
MAXPRO NVR automatically discovers its supported encoders and displays them in the
Camera Discovered pane as shown in the
Figure 6-17 Encoder discovery
C O N F I G U R I N G M A X P R O N V R
Configuring the Cameras
for the most up to date list of encoders
Figure 6-17.
141