Figure 4-9 Choose Location For Maxpro Nvr Database And Metadata Path - Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual

I N S T A L L I N G T H E N V R S O F T W A R E
4
Full Installation
6.
Figure 4-9
7.
Note:
72
Click Next. The SQL credentials validation status appears. After successful validation, the
Choose Database and Metadata Location screen appears
Choose location for MAXPRO NVR database and Metadata Path
There are two scenarios that are possible here, depending on your installation type:
• For Fresh installation of a MAXPRO NVR Database: The default path where the
MAXPRO NVR database is created automatically displays for a MAXPRO NVR
database fresh installation. Click Next to use the default path or click Browse to
select a new path if necessary and then click Next. The Choose Recording Drives
screen (Figure 4-10) appears.
• To retain the existing MAXPRO NVR Database: The path where the MAXPRO NVR
database is saved for a previously installed version of the MAXPRO NVR software
automatically displays. Click Next. A message "Trinity Database file already exists.
Do you want to retain the database" appears. If you
• Click Yes. The Localization Support screen
• Click No. The Choose Recording Drives screen
• Click Browse to select a new path for Metadata if required and then click Next. The
Choose Recording Drives screen
Metadata path can be changed from the default location to a separate Metadata
partition as recommended in the
Downgrade to previous version of NVR is only supported if user has restored the
Database backup during installation. For example: If user upgrades from 4.1 to
5.0 and if for any reason uninstalls the 5.0 build then, 4.1 installation will also be
uninstalled from the machine. If user has restored the DB backup during 5.0
installation then downgrade (4.1) build will be available.
(Figure 4-9).
(Figure 4-11) appears.
(Figure 4-10) appears.
(Figure 4-10) appears.
Before you Begin section.
MAXPRO NVR 5.0 Installation and Configuration Guide