Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual page 327

MAXPRO NVR 5.0 Installation and Configuration Guide
2. Open web.config file in notepad and check the below 2 entries:
<add key="RedirectStreamtoNVR" value="0"/>
<add key="EnableDisableCamera" value="0"/>
3. By default both are set to "0". means it is disabled. To enable the feature change the
value from 0 to 1 as highlighted below.
Note:
Once Video On Demand is configured to be used in MAXPRO NVR then
Enable/Disable camera feature can be turned off.
To enable this feature in MAXPRO VMS Server then perform the following steps:
1. Navigate the path in VMS C:\Program Files (x86)\Honeywell\UVISOM.
2. Repeat the step 2 to step 3 of
Camera stream Redirect to NVR in ISOM
Note:
Make sure MAXPRO Web client is working.
Scheduled Metadata and Database Backup
How to allow Enable/Disable of cameras and Enable
section.
A P P E N D I X A
327