Connecting The Monitors; Powering On The Maxpro Nvr Unit; Changing The Maxpro Nvr Ip Address And Machine Name - Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual

Connecting the Monitors

Powering on the MAXPRO NVR Unit

T o po w er on t he M A X P RO N V R u ni t
To turn off the power for MAXPRO NVR
Changing the MAXPRO NVR IP Address and
Machine Name
MAXPRO NVR 5.0 Installation and Configuration Guide
Connect one or more local monitors to one of the monitor connections on the back panel of
your MAXPRO NVR unit. The number of monitors that you can connect to the MAXPRO NVR
unit varies based on the NVR Edition you purchase. Refer to the specific
Sheet on Honeywell Video web site (www.honeywellvideo.com) for more information.
Note:
Honeywell recommends using an Uninterrupted Power Supply (UPS) for the
MAXPRO NVR unit and the cameras. Powering the cameras and unit from a UPS
ensures that the MAXPRO NVR unit can continue to record video during a power
outage or during transient power events. If you need to monitor video during a
power outage, consider a UPS for the client workstations as well.
1. Turn on camera(s) and other hardware connected to the MAXPRO NVR unit.
2. Press and hold the power button on front of the MAXPRO NVR unit. The power button
turns "blue" after the MAXPRO NVR unit is turned on.
3. After powering on the unit, you are prompted to log on. For MAXPRO NVR turnkey units
shipped with v4.0 or later version, the default Windows desktop login user has user
name: NVR-Admin, password: Password$123. The user name and password are case
sensitive. You will be prompted to create a new password the first time that you log in.
After logging on, the MAXPRO NVR Wizard automatically starts up but may take two
minutes to initiate.
Note:
Honeywell recommends to disable the Administrator User account and create a
new Administrator User account. See
255 for more information.
1. Close the MAXPRO NVR application.
2. Click Start>Shut Down. Wait for the MAXPRO NVR unit to shut down.
Your MAXPRO NVR unit has pre-configured network ports with the following default IP
addresses:
• 192.168.1.101 for NIC1 (Camera Network)
• 172.25.254.101 for NIC2 (Client Workstation Network)
S E T T I N G U P T H E M A X P R O N V R
Setting up the MAXPRO NVR Turnkey Box Solutions
Securing MAXPRO NVR
MAXPRO NVR Data
section on page
49