Figure 6-12 Camera Properties Pane - Honeywell MAXPRO NVR Series Hardware Installation And Configuration Manual

Configuring the Camera Properties
MAXPRO NVR 5.0 Installation and Configuration Guide
5. For the required camera, click
see Figure 6-12.
Figure 6-12 Camera Properties pane
6. Click Launch Camera Web Page to launch the web page for the camera. Use the
camera's web page to view IP and firmware settings, bit rate statistics, camera exposure,
day night and white balance settings, and set up video motion detection and other
analytic events.
7. Under General > PTZ > PTZ Settings
• Device Type - Select whether the camera is a PTZ or fixed.
• PTZ Sensitivity - Select the PTZ Sensitivity for PTZ camera. Available PTZ options
are: Minimum, Low, Normal, High and Maximum.
Note:
The PTZ Sensitivity field is not available for fixed cameras.
8. Under General > 360 Settings
C O N F I G U R I N G M A X P R O N V R
Configuring the Cameras
on the left corner to open the camera properties pane
131