Figure 6-13 Auto Discovery Window; Configuring The Auto Discovery Settings - Honeywell MAXPRO NVR Hybrid XE Installation And Configuration Manual

C O N F I G U R I N G M A X P R O N V R
6
Configuring the Cameras
9.
10.

Configuring the Auto Discovery Settings

The Auto Discovery Settings enable you to select the IP address range for discovery, set the
video format (NTSC/PAL), username and password of a camera as it is being added to the
NVR from the Discovery window. The Username and Password set for the camera in
MAXPRO NVR must match the username and password on the camera (actual device) to
stream video into MAXPRO NVR. See
Note:
Figure 6-13
To configure the Auto Discovery Settings
146
Under Primary Stream > Preferences > Stream Preferences Settings. See
more information.
Click Save.
Auto Discovery Settings are only applicable for Honeywell, AXIS and ONVIF
cameras.
Auto Discovery Window
• On the Camera page, click the Auto Discovery button, the Auto Discovery screen
appears. Perform the following:
• Under Select the IP Address range for discovery, type and set the IP address
in From and To fields.
• Under Settings, select "NTSC" or "PAL" from Video Format list.
• Under Set camera credentials
• Type a Username for the camera.
• Type a Password for the camera.
Figure 6-13.
MAXPRO NVR 5.6 Installation and Configuration Guide
step 5 for