Control With Function Keys - Siemens SIPROTEC 5 V7.80 Operation

Operation in the Operating State
8.9 Control System on Site
[scaktvor-210311-01.tif, 1, en_US]
Figure 8-73
Table 8-13
Name
Seting/operate
Switching (operation)
Switching (non-interlocked)
Switching Authority
Switching (without synchro-
check)

Control with Function Keys

8.9.11
8 of 9 function keys can also be used for control. Function key <F9> is hardcoded for language switching.
Using a function key you can initiate a switching sequence, for example, to switch on a feeder.
•
You reach the function keys by pressing the blue <Fn> key and the corresponding digit from <1> to <9>
in the numerical keypad.
•
Define your switching sequence using the CFC editor.
•
Link a single command (type SPC) in the information routing matrix with the desired function key.
•
Connect this single command with a SPC_INFO block that starts the switching sequence.
188
Assignment of Confirmation IDs
Confirmation IDs
Description
Authorization to change settings on the device display and DIGSI 5
To prevent unintentional switching of combined protection and control
devices, this general authorization for switching on site is available.
Release for manual setting of markers
Only in devices without key switch authorization for non-interlocked
switching (only effective in devices with parameterized switchgear inter-
locking protection conditions)
Only in devices without the key switch release of On-site switching
authority and hence of control on the device display
Authorization for unsynchronized switching of a circuit breaker (only in
devices with activated synchrocheck)
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-9, Edition 06.2018