Interlogix NS4750-24S-4T-4X-V2 Command Manual page 89

spanning-tree
restricted-tcn
Default:
Disabled
Usage Guide:
To enable Restrict topology change notifications of CIST Normal Port
Configuration for specific interface
Example:
To enable Restrict topology change notifications of CIST Normal Port
Configuration for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # spanning-tree restricted-tcn
speed
Command:
speed [10 | 100 | 1000 | 10g | auto]
speed Configures interface speed. If you use 10, 100, or 1000 keywords with
the auto keyword the port will only advertise the specified speeds.
10 10Mbps
100 100Mbps
1000 1Gbps
10g 10Gbps
auto Auto negotiation
Default:
Auto
Usage Guide:
To configure line speed for specific interface
Example:
To configure line speed (1Gbps) for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # speed 1000
switchport access vlan
Command:
switchport access vlan <vlan_id>
switchport Switching mode characteristics
access Set access mode characteristics of the interface
vlan Set VLAN when interface is in access mode
<vlan_id> VLAN ID of the VLAN when this port is in access mode
Default:
1
Usage Guide:
NS4750-24S-4T-4X-V2 Managed Switch Command Guide
Spanning Tree protocol
Restrict topology change notifications
Chapter 4: Commands for CLI configuration
87